| Control mode： |
Sensorless vector control（SVC）; V/F control |
| Startup torque： |
0.5Hz/150%; 0.5Hz/100% |
| Speed range： |
-1.1; 1:50 |
| Speed stability accuracy： |
±0.5%; ±1% |
| Carrier frequency： |
0.5kHz ～ 16kHz; the carrier frequency is automatically adjusted based on the load features. |
| Overload capacity： |
G type: 60s for 150% of the rated current, 1s for 180% of the rated current; P type: 60s for 120% of the rated current, 1s for 150% of the rated current. |
| Torque boost： |
Fixed boost; Customized boost 0.1% ~ 30.0%. |
| Running command source： |
Three command source：operation panel; control terminals; serial communication port; You can perform switchover between these sources in various ways. |
| Frequency source： |
There are 10 frequency sources in total, such as digital setting, analog voltage setting, analog current setting, pulse setting and serial communication port setting; You can perform switchover between these sources in various ways. |
| Auxiliary frequency source： |
There are ten auxiliary frequency sources. It can implement fine tuning of auxiliary frequency and frequency synthesis. |
| Input terminal： |
◆ 6 digital input terminals (DI); ◆ 2 analog input terminals (AI) |
| Output terminal： |
◆ 1 open-collector output terminal ; ◆ 2 relay output terminal; ◆ 2 analog output terminal |
| DC braking： |
Braking time: 0.0s ～ 100.0s; Braking action current value: 0.0% ～ 100.0% |
| V/F curve： |
Three modes: straight-line V/F curve, multi-point V/F curve, square V/F curve. |
| Ramp mode： |
Straight-line ramp, S-curve ramp; Four kinds of acceleration/deceleration time with the range of 0.0-6500.0s. |
| Simple PLC/Multiple speeds： |
It implements up to 16 speeds via the simple PLC function or combination of DI terminal states. |
| Built-in PID： |
It realizes process-controlled closed loop control system easily. |
| AVR function： |
It can keep constant output voltage automatically when the mains voltage changes. |
| Overvoltage/Overcurrent stall control： |
The current and voltage are limited automatically during the running process so as to avoid frequent tripping due to overvoltage and overcurrent. |
| Rapid current limit： |
It helps to avoid frequent overcurrent faults of the AC Drive. |
| Torque limit and control： |
It can limit the torque automatically and prevent frequent over current tripping during the running process. |
| Timing control： |
Timing control function: time range: 0h ～ 65535h |
| Protection mode： |
Motor short-circuit detection at power-on, input/output phase loss protection, overcurrent protection, overvoltage protection, undervoltage protection, overheat protection, overload protection and so on. |
There are no reviews yet.